Specification
Item
Data
Application
Vertical & Horizontal
Installation Mode
Add-on
Table diameter(mm)
Ø210
Inner diameter of mandrel sleeve(mm)
Ø40H7
Diameter of center through hole(mm)
Ø40
Table height (Horizontal)(mm)
310
Table T-slot width(mm)
12H7
Guide block width(mm)
18h7
Axis / Rotation
360°
Axis / Tilt
(-100°~+100°)
Rotary Axis Transmission Mechanism
Direct Drive
Tilt Axis Transmission Mechanism
Direct Drive
Min. increment(deg.)
0.001
Rotation Axis Cooling System
Free Cooling / Oil Cooling
Tilt Axis Cooling System
Free Cooling / Water Cooling
Rotation Axis Indexing precision(sec.)
20
Rotation Axis Repeatability(sec.)
4
Tilt Axis Indexing precision(sec.)
30
Tilt Axis Repeatability(sec.)
4
Rotation Axis Clamping system(kg/cm²)
Pneumatic (0.6 / 6)
Tilt Axis Clamping system(kg/cm²)
Pneumatic (0.6 / 6)
Rotation Axis Clamping torque(kgf · m)
31
Tilt Axis Clamping torque(kgf · m)
45
Rotation Axis Sever motor model(FANUC)(Straight shaft without key)(Taper)
Fanuc Dis Direct Drive Motor
Tilt Axis Sever motor model(FANUC)(Straight shaft without key)(Taper)
Fanuc Dis Direct Drive Motor
Rotation Axis Speed reduction ratio
Direct Drive
Tilt Axis Speed reduction ratio
Direct Drive
Rotation Axis Rated / Max. Speed (r.p.m)
200 / 300
Tilt Axis Rated / Max. Speed (r.p.m)
150 / -
Rotation Axis Rated / Max. Cutting Torque)(Nm)
40 (Oil cooling 80) / 200
Tilt Axis Rated / Max. Cutting Torque)(Nm)
150 / -
Allowable inertia load capacity (Horizontal)(kg-m²)
0.28
Rotation Allowable workpiece load (0˚Horizontal)(kg)
50 (Rated Speed)
Rotation Allowable workpiece load (0˚~90˚Tilt)(kg)
30 (Rated Speed)
Rotation Allowable thrust load (with rotary table clamping) F (N / kgf)
400
Rotation Allowable thrust load (with rotary table clamping) FxL (N.m / kgf·m)
45
Rotation Allowable thrust load (with rotary table clamping) FxL (N.m / kgf·m)
31
Net Weight (D.D motor included)
237
Dimension
