Specification
Item
Data
Application
Vertical & Horizontal
Installation Mode
Add-on
Table diameter(mm)
Ø300
Inner diameter of mandrel sleeve(mm)
Ø25H7 x 12 deep (Diameter of table hole)
Table height (Horizontal)(mm)
385
Table T-slot width(mm)
14H7
Guide block width(mm)
14h7
Axis / Rotation
360°
Axis / Tilt
(-120°~+120°)
Rotary Axis Transmission Mechanism
Direct Drive
Tilt Axis Transmission Mechanism
Direct Drive
Min. increment(deg.)
0.001
Rotation Axis Cooling System
Water cooling
Tilt Axis Cooling System
Water cooling
Rotation Axis Indexing precision(sec.)
20
Rotation Axis Repeatability(sec.)
4
Tilt Axis Indexing precision(sec.)
30
Tilt Axis Repeatability(sec.)
4
Rotation Axis Clamping system(kg/cm²)
Pneumatic (0.6 / 6)
Tilt Axis Clamping system(kg/cm²)
Pneumatic (0.6 / 6)
Rotation Axis Clamping torque(kgf · m)
43
Tilt Axis Clamping torque(kgf · m)
73
Rotation Axis Sever motor model(FANUC)(Straight shaft without key)(Taper)
DD Motor
Rotation Axis Sever motor model(MITSUBISHI)(Straight shaft without key)(Taper)
DD Motor
Tilt Axis Sever motor model(FANUC)(Straight shaft without key)(Taper)
DD Motor
Tilt Axis Sever motor model(MITSUBISHI)(Straight shaft without key)(Taper)
DD Motor
Rotation Axis Speed reduction ratio
Direct Drive
Tilt Axis Speed reduction ratio
Direct Drive
Rotation Axis Rated / Max. Speed (r.p.m)
818 / 2000(600VDC)
Tilt Axis Rated / Max. Speed (r.p.m)
50 / 50
Rotation Axis Rated / Max. Cutting Torque)(Nm)
113 / -
Tilt Axis Rated / Max. Cutting Torque)(Nm)
554 / 741
Allowable inertia load capacity (Horizontal)(kg-m²)
1.13
Rotation Allowable workpiece load (0˚Horizontal)(kg)
100 (Rated Speed)
Rotation Allowable workpiece load (0˚~90˚Tilt)(kg)
100 (Rated Speed)
Rotation Allowable thrust load (with rotary table clamping) FxL (N.m / kgf·m)
73
Rotation Allowable thrust load (with rotary table clamping) FxL (N.m / kgf·m)
43
Net Weight (D.D motor included)
730
Dimension
