Specification
Item
Data
Application
Vertical & Horizontal
Installation Mode
Integrated
Table diameter(mm)
Ø500
Inner diameter of mandrel sleeve(mm)
Ø25H7 x 12 deep (Diameter of table hole)
Table T-slot width(mm)
14H7
Axis / Rotation
360°
Axis / Tilt
(-110°~+110°)
Rotary Axis Transmission Mechanism
Direct Drive
Tilt Axis Transmission Mechanism
Direct Drive
Min. increment(deg.)
0.001
Rotation Axis Cooling System
Water cooling
Tilt Axis Cooling System
Water cooling
Rotation Axis Indexing precision(sec.)
20
Rotation Axis Repeatability(sec.)
4
Tilt Axis Indexing precision(sec.)
25
Tilt Axis Repeatability(sec.)
4
Rotation Axis Clamping system(kg/cm²)
Pneumatic (0.6 / 6)
Tilt Axis Clamping system(kg/cm²)
Pneumatic (0.6 / 6)
Rotation Axis Clamping torque(kgf · m)
85
Tilt Axis Clamping torque(kgf · m)
200
Rotation Axis Sever motor model(FANUC)(Straight shaft without key)(Taper)
DD Motor
Rotation Axis Sever motor model(MITSUBISHI)(Straight shaft without key)(Taper)
DD Motor
Tilt Axis Sever motor model(FANUC)(Straight shaft without key)(Taper)
DD Motor
Tilt Axis Sever motor model(MITSUBISHI)(Straight shaft without key)(Taper)
DD Motor
Rotation Axis Speed reduction ratio
Direct Drive
Tilt Axis Speed reduction ratio
Direct Drive
Rotation Axis Rated / Max. Speed (r.p.m)
596 / 800
Tilt Axis Rated / Max. Speed (r.p.m)
50 / 50
Rotation Axis Rated / Max. Cutting Torque)(Nm)
402 / -
Tilt Axis Rated / Max. Cutting Torque)(Nm)
1217 / 2120
Allowable inertia load capacity (Horizontal)(kg-m²)
6.25
Rotation Allowable workpiece load (0˚Horizontal)(kg)
200 (balanced load)
Rotation Allowable workpiece load (0˚~90˚Tilt)(kg)
100 (balanced load)
Rotation Allowable thrust load (with rotary table clamping) F (N / kgf)
1500
Rotation Allowable thrust load (with rotary table clamping) FxL (N.m / kgf·m)
200
Rotation Allowable thrust load (with rotary table clamping) FxL (N.m / kgf·m)
85
Net Weight (D.D motor included)
914